Solid Works Surface Modeling

The goal of this course is to teach you how to use surface features to build parts using SolidWorks software. Most of the case studies and exercises in this course are taken from consumer product design applications, and the lessons center around the combined use of solids and surfaces, with the goal always being to create a good solid. During this course we will learn industry standard surfacing terminology necessary to understand a ground-up surface modeling approach, as well as answer some of the “when” and “why” questions which are inevitable with the solids to surfaces paradigm shift. If your modeling experience to date has been completely in the solids realm, you may find that working in surfaces requires a different approach.
.
Prerequisites : SolidWorks Fundamentals and minimum of 80 hours SolidWorks Modeling Time are required. SolidWorks Advanced Part Modeling is recommended


Various dates available. Contact us for availability
 

Registration Policy: 
Fee must accompany non-member registration.  Cancellation policies apply.  Cancellations with less than 10 days notice will be charged.  No shows will be charged.  



Register below  or 
Contact the MA Training Department at 

717-843-3891 or Training@MASCPA.org

*Please note that these classes are all grant sponsored and 

students will be required to complete the data forms.*




Date: June 2017
Sessions: 2 days
Times: 8 am - 5 pm
Location: 1851 Charter Lane, Lancaster PA 17605
Cost (member): $ 480- Grant
Cost (non-member): $ 480- Grant
REGISTER NOW

"EXACTLY what I was looking for" – A news reporter needing market data for story
The Manufacturers' Association
320 Busser Road, 2nd Floor
P.O. Box 493
Emigsville PA, 17318
(717) 843-3891
office@mascpa.org