CSS MenuMaker

MWSC Basic Making-Die Theory

Course Description:

39-hours
Principles of blanking and/or piercing dies; bending; screw and dowel holes; die life; punches; pilots; die-block construction; strippers and stock guides; shredders and knockouts; nest gages; pushers; die stops; stock materials utilization; strip layouts and die set are topics covered. Basic techniques and theories of building stamping dies are presented along with the essential facts of cutting and forming operations. Discusses primary die components as individual entities in addition to their function as an integral part of the complete die. 

Session Details:
This class will run on Mondays and Wednesdays, 6-9 pm

Book requirements:
Name: Basic Die Making Author: D. Eugene Ostergaard
ISBN: 0-07-046090-6
This can be found on amazon.com or www.ntma.org.

Register Below or
Contact the MA Training Department at 717-843-3891
Training@MASCPA.org 

Date: 1/03 - 2/14/2018
Sessions: 13
Times: 6 - 9 pm M&W
Location: MA, 160 Roosevelt Ave, Suite 400, York PA
Cost (member): 355
Cost (non-member): 533
REGISTER NOW

"A perfect speaker, at the perfect time. Your event always sets the tone for a business gathering in southcentral PA"   Annual Event attendee at 
Penn State's Pullo Center in York, PA
The Manufacturers' Association
160 Roosevelt Avenue
York, PA 17401
(717) 843-3891
office@mascpa.org