MWSC Geometric Dimensioning and Tolerancing (G,D & T)

Course Description:

This course is a study of the geometric controls set forth in ASME standard Y14.5M-1994 - Dimensioning and Tolerancing.

Course Objectives:

Upon completion of the course the student will demonstrate a beginner’s level ability to interpret a symbolic language used on engineering drawings to communicate geometric information.

Course Outline:

  • Material Condition Modifiers
  • Projected tolerance zones
  • Size & Form
  • Relationship between size and form
  • Tolerance zones
  • Inspection technique

Required Books: 
-Modern Geometric Tolerancing
              ISBN: 0-910399-21-3

-GDT Hiearchy Pocket Guide   
              ISBN: 978-0-9792781                          
2017/2018 Session Details: DATES UPDATED
30 Hours
Tuesdays and Thursdays, 6-9 pm
April 12- May 17, 2018

Register below  or 
Contact the MA Training Department at 
717-843-3891 or 

"A perfect speaker, at the perfect time. Your event always sets the tone for a business gathering in southcentral PA" –  Annual Event attendee at 
Penn State's Pullo Center in York, PA
The Manufacturers' Association
320 Busser Road, 2nd Floor
P.O. Box 493
Emigsville PA, 17318
(717) 843-3891