OSHA 10 & 30 Hour Training

10 & 30 -hour course, covering many OSHA regulations and providing insights into compliance requirements, reporting requirements, enforcement, penalties, general facility safety and techniques to use to minimize injuries and illnesses, to report them and to maintain a safe and healthy workplace.

Safety in the workplace is a must if you want your employees to be productive and your company profitable. Injuries and illnesses caused by unsafe acts and unsafe conditions are likely to happen when training, written programs, and procedures are not planned and implemented.  
OSHA Outreach Training for General Industry program focuses on SAFE management principles that can make your company both compliant with OSHA and a safe place to work. The OSH Act, PPE, Electrical Safety, Machine Guarding and the new Hazard Communication Rule (GHS) are some of the topics addressed in these programs.

During the training, you will learn the 3 main elements in any successful safety program. For example, do you know which OSHA rules require annual training? Which OSHA regulations require written programs? 
Do you know how to provide forklift training? 
How are scissor lifts regulated? Did you know that a lost time burn injury is estimated to cost you more than $57,000? 

Citations can cost you from several hundred to quite a few thousand dollars each all avoidable by taking simple steps in a sustainable safety program. 

  • Introduction to OSHA (Use the training materials prepared by OSHA)
  • Subpart D - Walking and Working Surfaces including Fall Protection
  • Subparts E and L - Exit Routes, Emergency Action Plans, Fire Prevention Plans, and Fire Protection
  • Subpart S Electrical
  • Subpart I - Personal Protective Equipment
  • Subpart Z - Hazard Communication
  • Subpart O - Machine Guarding
  • Subpart Z - Bloodborne Pathogens
  • Ergonomics
  • Lockout/Tagout
  • Managing Safety & Health
  • Subpart N - Materials Handling
  • Subpart J - Permit-Required Confined Spaces
  • Subpart O - Machine Guarding
  • Subpart Z Introduction to Industrial Hygiene
  • Subpart G Hearing Conservation
  • Subpart H - HAZWOPER

Note: The course content for each course is prescribed by OSHA. They also require a pre-test and post-test to document the effectiveness of the training.
Each attendee will receive a bound copy of the training materials and a certification of completion  and the  30-hour Card as appropriate.

10 hour Dates: 
30 Hour Dates: 

Register Below or
Contact the MA Training Department at 717-843-3891

"Thank you ... for participating in our Manufacturer's Summit" Adams County Economic Development Corporation
The Manufacturers' Association
320 Busser Road, 2nd Floor
P.O. Box 493
Emigsville PA, 17318
(717) 843-3891